My Classifieds

NG Elfin Bodykit

This aerodynamic, high-quality body kit will fit Elfin NG, Spectre and Elfin-copy chassis.

The History of Formula Vee Volumes 1 & 2

Is now on CD and contains over 300 Photos and Documents never seen before. From every state in Australia. This is volume one and volune two is in the pipeline. Any contributions are welcome.

Drive a Formula Vee!

Cade Southall Racing offers the chance to drive a single seat racing car at their corporate drive days.

Lifetime racing

Lifetime racing offers Formula Vee drive days in Victoria. Eric Irvine offers drives at Calder and Winton Raceways. See www.classicsportscars.com.au

Andy Goodall Racing

 

Borland Sabre Formula Vee

 

Scorpion KP01 1200cc

One of the most successful Formula Vee chassis made by Keith Poole in South Australia. This car was comissioned by David Turnbull and has been a consistent front runner.

NG Elfin Body moulds

Professionally built and rigid, gives an excellent finished product. Top body, LH&RH side panels and nose-cone moulds. All in excellent condition. Can arrange interstate transport

Short Box

No axles, has just been rebuilt by John Dean.

Pi Research C-Dash

Pi Research C-Dash with Momo Mod/11 steering wheel. The C-Dash is designed to replace the normal set of analogue instruments in a vehicle.

Gearbox

1200cc / Historic Vee Short Gearbox. FVAA Sealed ready to use (does not include alxes tubes or axles) Includes 1:26 3rd

Parts

2 Short gearbox's less axels & tubes 1 1.32 3rd gear 1 1.22 3rd gear Both unused since being checked & resealed with new gaskets by John Dean

Helmet

SHOEI race helmet in excelent condition to fit size medium.

1600 Crank Case

Fully line bored, galleries and clearances prepared. Ready for build up

1600cc engine

New case,crank,vernier cam,comes complete rocker cover to rocker cover & front pulley to clutch pressure plate, 2005 specification.

Sealed 1200cc engine

Built and maintained by VW performance (requires rebuild). Best offer will sell

Rims

I’m trying to locate a set of rims the same as pictured. Apparantly a guy in SA used to custom make them for vee’s but I can’t find any details on him or if there are any sets floating around for sale.

15" x 5.5" 5 stud Mags or Mangels Rims

Looking for 4 or 5 - 15" x 5.5" 5 stud Mags or Mangels Rims

Mag Wheels

Fide five pattern mag wheels wanted. The odder the better. Will buy singles. Located in Melbourne Victoria. Will travel. Anything considered.

FVee 1200 Parts

Exhaust System $150, Road Car 1200cc Motor and Gearbox $150

Enclosed Trailer

Fully enclosed trailer with workshop,240v lights and power points,sink, tyre rack. NO rego.Mechanically sound.just Repaint and register it.

Enclosed trailer

Single axle lift up roof 1600 wide internal 4300 long internal 4 inch drop axles good to tow.

Jacer 1600

This is a proven winning car. It was under the lap record of Ryan Simpson at the last sandown meeting.

1200 parts

1200 engine with many first place finishes in 2006.

REMINDER - 2006 National Challenge Entries Close

Entries for the 2006 Formula Vee National Challenge close 25/9/06. Please ensure entries are in the post by 24/9/06. Enquiries to Neil McLay, Ph (08) 9397 2093, Mobile 0419 945 078, email mclay@iprimus.com.au

New Sabre Body

 

Gearbox

Sealed, that was purchased at Queensland Raceway from the local top driver when we broke ours. I'm not sure if it is a high or low box but I seem to remember being told it had a much sought 3rd gear.

JABIRU 1600 GRD 06 inc Trailer

Front running Formula Vee 1600. Consistent Top 5 finishes in Victorian State Racing Championships and finished 5th at 2006 Nationals in Perth.

Swap a Nissan Skyline for a Formula Vee

Looking for 1600 formula vee but would like to swap plus cash for my R33 series 2 Skyline. Registered till March car value around $16000.

Rapier Formula Vee by Volks Engineering

State-of-the-art chassis. Revolutionary rear suspension. Placed third at its second race meeting. Available from rolling chassis to top-of-the-range turn-key with adjustable steering column and

2004 Jacer F2K4 1600

Comes with ball joint front end. 2nd set of wheels and tyres, dorian ,micron 3 dash. Finished 3rd place in 2004 NSW state championship driven by John Mostyn. Driven by rookie driver for 2 yrs.

V-Force Mag Wheels

Looking for a set of four V-Force mag wheels four stud with 20 off-set, all in good or better condition. Will consider all offers as required asap for 2008 season. Please supply relavent photos.

Mako 04

Car is in excellent condition having only done five meetings since new. Motor is two meetings old.

1600 Race Engine

Looking to buy complete 1600 and 1200 race engines. I would prefer if they came with all tinware and ancillaries, but I will happily consider engines that don't.

Parts

I have the following parts for sale: Solex 34 PICT-3 Carburetors ready to bolt on and race, Dunlop tyres front and rear – 2/3 meetings old, 1 1600 Pressure Plate, 1 1600 Clutch

1200 Carby jets

I am looking for main and air correction carby jets for a 1200. Drilled to size or standard.

1200 Formula Vee

Formula Vee frame and front end plus all the body work could be a cheap way to get into 1200cc racing. Just add motor, box and wheels and you are ready to go.

Luke Warner Racing Drive Days

Ever Wanted to drive a real open wheeler race car on a real race track. With the option of a half or full day experience you are sure to enjoy.

1200 Race Engine & Long Box

 

Formula Vee 3 Piece Alloy Rims

These rims can be supplied in both 5.5 inch and 6 inch configuration. CNC machined centres are from aircraft quality alloy and supplied in "as machined" finish or your choice of

Mangels Rims

2x 4.5 & 2x 5.5, 5 stud pattern. Aesthetic condition not important, will sandblast and powdercoat. Happy to build set over time if single rims available only.

Racing Mirrors

Traditional style and F3 style race mirrors

NSW-Empi wheels

1 x set near new 15 x 5.5 Empi wheels Used only once in practice at Wakefield.